GARDEN MASTER GM2315 조립 지침 매뉴얼 - 페이지 2
{카테고리_이름} GARDEN MASTER GM2315에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDEN MASTER GM2315 8 페이지. Sloping roof shed
GARDEN MASTER GM2315에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (8 페이지)
페이지 인쇄
ASSEMBLY OVERVIEW
These instructions are designed to guide you though the process
of building your new garden shed. It is a simple process of joining
sheets together before adding top and bottom channels to form a
shed panel. These panels are then joined together to make your shed.
When fitting the channels to the sheets, the high side of the channel should go on the inside of the sheet, ensuring that
any water that collects in the bottom channel will run over the lower side and run away rather than into the shed.
Rivets are fitted by drilling through outside of the channel into the ribs of the sheet, usually at every second rib. It is
also important to fit at least one rivet per sheet from the inside of
the channel into the pan of the sheet, close to a rib. Extra rivets
should be fitted on the inside of the channel into the pan of the
sheets in high wind areas.
It is critical that you remove the swarf (the metal filings created
when drilling) from the panels and channels as you assemble
them as these will rust quickly and could cause corrosion issues
with your shed!
COMPONENTS CHECKLIST
Please check the parts carefully and advise immediately if any are damaged or missing.
3 x 1830mm sheets for the back
A
1 x 740mm wide sheet with door
D
jamb attached
4 x 2255mm channels with ends cut for
G
front and back walls
1 x pack of rivets, 1 x riveter, 1 x drill bit. and a padbolt pack with wide
J
flanged rivets for fixing the padbolt on to the door and door jamb.
If you need advice, call us
2
If you choose to vary from these instructions your warranty will be impaired.
4 x 1980mm - 1830mm sloping sheets
B
(side walls 2 left, 2 right)
Door pre-hinged to 740mm sheet with
E
door jamb
2 x 1830mm 'L's for flashing the roof to
H
the side walls
FREE
on
0800 807 433
or email us at [email protected]
INSIDE
OUTSIDE
3 x 1830mm sheets for the roof
C
4 x 1515mm channels for end walls
F
2 x 2255mm channels for the roof
2 x 793mm door spacers
I
2 x 'Z' door braces
K
RIB
PAN