Jandy Jandy Pro Series 설치 및 운영 매뉴얼 - 페이지 14

{카테고리_이름} Jandy Jandy Pro Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy Jandy Pro Series 20 페이지. Single element cartridge pool & spa cs filters
Jandy Jandy Pro Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (20 페이지), 소유자 매뉴얼 (20 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (2 페이지), 설치 지침 (2 페이지), 설치 및 운영 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (16 페이지)

페이지 인쇄

Page 14

ENGLISH

4.3

Change Fill Time for Safety Lockout

Mode

To change the pre-set factory Fill time, turn off the

power to the control box, open it up, and cut one or both

jumpers on the circuit board.

WARNING

Turn off the power to the control box before starting

this procedure. Failure to comply may cause a shock

hazard, resulting in severe personal injury or death.

Shut off the power to the control box.

Take the upper cover plate off the control box by

removing the three (3) screws that secure it.

Locate the jumpers at the top left of the circuit

board. See Figure 11.

Modify the Fill time by cutting Jumpers A and/or

B, as shown in Table 3, below.

Table 3. Fill Safety Lockout Mode Settings

Jumper(s)

Fill Time Period

Factory Default

20 minute Fill before Lockout

Cut Either A or B

40 minute Fill before Lockout

Cut Both A and B

60 minute Fill before Lockout

NOTE Cutting the S-1 Jumper will disable the Safety-

Lockout function.

Replace the top cover plate, being careful to align

the LED lights with the plastic lenses in the cover.

Install the three (3) screws. Do not tighten or you

will damage the plastic mounts.

Restore the power to the control box. The new

timing changes will take effect.

NOTE If you change the Fill Safety Lockout Mode

settings without turning the power off in

advance and on afterwards, you will need to

cycle the power from OFF to ON for the new

timing changes to take effect.

Jandy Pro Series Levolor

II Electronic Water Leveler

Models K-2100

Lockout

Jumpers

Figure 11. Safety Lockout Jumpers

Installation and Operation Manual

S 1