Jandy Jandy Pro Series 소유자 매뉴얼 - 페이지 18

{카테고리_이름} Jandy Jandy Pro Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy Jandy Pro Series 20 페이지. Single element cartridge pool & spa cs filters
Jandy Jandy Pro Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 설치 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (20 페이지), 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (2 페이지), 설치 및 운영 매뉴얼 (20 페이지), 설치 지침 (2 페이지), 설치 및 운영 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (16 페이지), 설치 및 운영 매뉴얼 (16 페이지)

페이지 인쇄
Jandy Jandy Pro Series 소유자 매뉴얼
Page 18

Section 10. Troubleshooting

Use the troubleshooting information in the following table for suggestions.
Symptom
All lights fail to illuminate Lights are not reciev-
One or more lights are
dim, blinking or not
working
Colored lights out of
synch
Light is blinking
ENGLISH
Problem
ing power
Poor connection or
improper wire gauge
Improper voltage
supply or poor con-
nection to the light
Light is too hot
Nicheless Underwater LED Lights | Owner's Manual
Corrective Action
Check 120VAC power supply
into transformer. Check for
12VAC output at transformer.
Check or reset GFCI. Make
sure 120 volts has not been
used in the installation - if so
damage is assured and is NOT
WARRANTABLE.
Separate each light and
independently wire 12V to the
single light only. Repeat this
process on each light. If junc-
tion box is being used, check
for proper connection of light
cord. Verify that the correct wire
gauge is being used between
the transformer and junction
box.
Verify that proper wire connec-
tions are being achieved for
the lights that are out of sync.
Reset all the lights to white by
turning lights OFF for five (5)
seconds, then turning ON
Confirm that the light is
submerged in water that does
not exceed a temperature of
104F (40C)