Jandy Jandy Pro Series Руководство пользователя - Страница 18

Печатать страницу

Jandy Jandy Pro Series Руководство пользователя

1. Section 10. Troubleshooting

Page 18

Section 10. Troubleshooting

Use the troubleshooting information in the following table for suggestions.

Symptom

All lights fail to illuminate Lights are not reciev-

One or more lights are

dim, blinking or not

working

Colored lights out of

synch

Light is blinking

ENGLISH

Problem

ing power

Poor connection or

improper wire gauge

Improper voltage

supply or poor con-

nection to the light

Light is too hot

Nicheless Underwater LED Lights | Owner's Manual

Corrective Action

Check 120VAC power supply

into transformer. Check for

12VAC output at transformer.

Check or reset GFCI. Make

sure 120 volts has not been

used in the installation - if so

damage is assured and is NOT

WARRANTABLE.

Separate each light and

independently wire 12V to the

single light only. Repeat this

process on each light. If junc-

tion box is being used, check

for proper connection of light

cord. Verify that the correct wire

gauge is being used between

the transformer and junction

box.

Verify that proper wire connec-

tions are being achieved for

the lights that are out of sync.

Reset all the lights to white by

turning lights OFF for five (5)

seconds, then turning ON

Confirm that the light is

submerged in water that does

not exceed a temperature of

104F (40C)