Brizo Charlotte T60485 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Brizo Charlotte T60485에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brizo Charlotte T60485 20 페이지. Valve trim
Brizo Charlotte T60485에 대해서도 마찬가지입니다: 설치 지침 및 사용 설명서 (20 페이지)

페이지 인쇄

60 Series Installation

Showerhead and Tub Spout Installation

NOTE: It is suggested that you anchor your shower arm and tub spout

elbows or water lines.

RP70908s

(3) = 3/8" - 1/2" (9.5 mm - 12.7 mm)

FOR TUB SPOUT INSTALLATION:

Install 1/2" (13 mm) threaded pipe nipple (1) to

extend past finished wall (2) per dimension (3).

Connection of deck mount spouts to in–wall

valves is not recommended. Neither is the use

of hand showers connected to tub spouts in a

tub/shower push button diverter combination, or

hand showers connected in lieu of a tub spout

to a tub / shower valve.

Piping between valve body and tub spout must

be a minimum of 1/2" (13 mm) copper pipe

or 1/2" (13 mm) iron pipe in a straight drop

no less than 8" (203 mm) but no more than

18" (457 mm) long with only one iron pipe or

copper 90 degree elbow to the tub spout nipple.

FOR SHOWERHEAD INSTALLATION:

Connect top outlet (1) to shower arm (2) with

proper fittings. Apply Teflon

on both ends of showerarm. To prevent damage

to finish on shower arm, insert wall end of shower

arm into shower flange (3) before screwing arm

into riser connection. Thread showerhead (4) onto

shower arm. Do not overtighten showerhead.

Install a 1/2" threaded pipe nipple to extend

beyond the finished wall 3/8" to 1/2". Apply Teflon

tape to thread on pipe nipple and screw brass

adapter (1) securely onto nipple. Install set screw

on bottom of spout (2) making sure it is not

sticking through to the inside opening where it

could interfere with the assembly. Slide tub spout

over the adapter and tighten set screw, on bottom

of spout, against the adapter. Note: This spout

utilizes a pull down diverter mechanism. To

divert from spout to shower, pull down on

spout tip (3).

tape to pipe threads