Jandy AquaLink RS 설치 지침

{카테고리_이름} Jandy AquaLink RS에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy AquaLink RS 1 페이지. Battery wireless, portable control panel
Jandy AquaLink RS에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 지침 (1 페이지), 설치 매뉴얼 (4 페이지)

페이지 인쇄

AquaLink

Installation Instructions- Jandy p/n 6796

DIP

Sw itch

# 2 on

Turn off power.

IMPORTANT: TURN OFF ALL POWER AT THE BREAKERS BEFORE PROCEEDING.

Mount relay.

The Two-speed Relay must be mounted in one of the four positions on the lower step of the relay

compartment in the AquaLink Power Center. If necessary, remove a relay from the bottom step and

re-install it on the top step to make room for the Two-speed Relay. Mount the relay using one screw

as shown in the diagram above.

Wire relay.

Using high voltage wire, connect the normally open (NO) wire from the Two-speed Relay to the low

speed terminal on the filter pump. Connect the normally closed (NC) wire from the Two-speed relay to

the high speed terminal on the filter pump. Connect the common (C) wire to a Load terminal on a

standard Jandy relay, and connect the other Load on that standard relay to the common terminal on

the filter pump. Connect the Line terminals of the standard relay to 240 VAC power. Connect the coil

connectors of the Two-speed Relay to the Aux. 2 socket on the Power Center P.C. Board (see wiring

diagram on Power Center door and in Installation Manual).

Turn on DIP Switch #2.

For the system to recognize that it is connected to a two-speed pump, you must move DIP Switch #2

on the Power Center Dip Switches to the ON position.

Test system; program Controller.

Check your wiring, then turn power back on. The module may be tested by using the Service Mode

button on the Power Center, but note that this mode allows only on/off switching. The two speed

function is only available through the Controller or a Spa Side Switch. See main Owner's Manual, and

follow the directions under "Label Auxiliaries" on page 8.

Sheet # 6947 Rev. D, 1/01

Two-Speed Relay

6000 Condor Drive, Moorpark, CA, USA 93021 • 707.776.8200 FAX 707.763.7785

480 S. Service Road West, Oakville, Ontario, Canada L6K 2H4 • 905.844.8233 FAX 905.844.2635

For Technical Support call 707-776-8200, ext. 260

TO FILTER PUM P

SO CKE T

R ED

RED

BLK

H IG H

LO W

TO AUX 2

SO CKE T

24 0

VA C

F ilte r

P um p