Jandy AquaLink RS 설치 지침

{카테고리_이름} Jandy AquaLink RS에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Jandy AquaLink RS 1 페이지. Battery wireless, portable control panel
Jandy AquaLink RS에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 지침 (1 페이지), 설치 매뉴얼 (4 페이지)

페이지 인쇄

AquaLink

Installation Instructions- Jandy part #6590

Caution

Do not mount the TeleLink PCB in the

AquaLink Power Center. Keep in original

TeleLink enclosure.

The TeleLink enclosure will need to be installed as close as possible to a phone jack to keep the phone cord as

short as possible between the phone and the TeleLink. The TeleLink will need the phone cord to communicate with

the house phone. Run the 4-conductor wire from the TeleLink either to the AquaLink Power Center (connect to the

red 4-pin terminal bar) or the AquaLink indoor controller (connect to the red 4-pin terminal bar, the wires may be

doubled-up on the terminal bar). If running the 4-conductor wire to the AquaLink RS Power Center, use a strain

relief on one of the knockouts on the bottom of the Power Center.

NOTE: If you are installing more than one accessory board, order and use a Jandy Multiplex PCB Kit,

(p/n 6584). Never put more than two wires into each of the pins of the red terminal bar. Use the Multiplex PCB

whenever more than two of the 4-conductor wire are being connected.

Sheet # 6862 Rev. F

RS TeleLink

Program

# of rings

(default: 4)

6000 Condor Drive, Moorpark, CA, USA 93021 • 707.776.8200 FAX 707.763.7785

For Technical Support call 707-776-8200, ext. 260

Telephone Interface

AquaLink RS

TeleLink Board

To RS485

4-Conductor

(Cable between

Controller and

Power Center)

Program

access code

(default: 62)

Phone Cable

from Wall Jack.

Cable