Gardena Classic 4000/5E 사용 설명서 - 페이지 10

{카테고리_이름} Gardena Classic 4000/5E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena Classic 4000/5E 18 페이지. Electronic pressure pump

페이지 인쇄

Problem

Info-LED blinks 3 times.

During the current operation,

the pump has extracted no

water for 30 seconds.

Water supply disrupted on the

suction side

Only Art. no. 1758: Flow Sensor

signal faulty

Pump motor does not start

anymore

Info-LED blinks 4 times.

During operation, the pump

switched off after 60 minutes.

Leakage warning activated

Only Art. no. 1758:

Flow Sensor signal faulty

Pump motor does not

start or stops suddenly

during operation

Possible Cause

Problem on pump side.

Suction hose bent.

Flow Sensor blocked.

Thermal circuit breaker activated

(motor overheated).

Leak on pressure side

(e. g. dripping tap).

Exceeded maximum duration

(60 mins.) of the low quantity

programme.

Check valve contaminated.

Flow sensor contaminated

FI was triggered because fault

current was detected.

Switch is not turned to I.

Mains plug not plugged in.

Power failure.

Remedy

v Immerse suction hose end

under water,

v eliminate leak on the suction

side,

v clean check valve on the

suction line and check the

mounting direction,

v clean suction filter on the

suction hose end,

v clean filter lid washer and

screw lid until the stop

(see 7. Maintenance),

v clean fine-mesh filter in the

pump.

v Use a new suction hose.

v Clean Flow Sensor (see

"Cleaning the flow sensor").

v Allow the pump to cool

down for 20 minutes.

v Eliminate leak on pressure

side.

v When using the low quantity

programme, shorten

the watering duration or

interrupt for 5 minutes

(see 3. Function).

v Increase water consumption.

v Clean check valve in pump

(see 7. Maintenance)

v Clean flow sensor inside the

pump (see 7. Maintenance).

v Disconnect pump and

contact GARDENA Service.

v Restart the pump

(see 5. Operation).

v Insert mains plug into

a mains socket (230 V AC).

v Check fuse and cables.