Lexmark E360D series (독일어) 보충 설명서 - 페이지 7

{카테고리_이름} Lexmark E360D series에 대한 (독일어) 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Lexmark E360D series 9 페이지. Loading paper
Lexmark E360D series에 대해서도 마찬가지입니다: 설정 및 설치 (2 페이지), 브로셔 및 사양 (4 페이지), 브로셔 및 사양 (4 페이지), 빠른 참조 (2 페이지), 보충 설명서 (5 페이지), 문제 해결 매뉴얼 (8 페이지)

페이지 인쇄

Place the unit on a flat, clean surface.

Press the button on the base of the photoconductor kit. Pull

the toner cartridge up and out using the handle.

Unpack the new photoconductor kit. Be careful not to touch

the photoconductor drum.

Insert the toner cartridge into the photoconductor kit by

aligning the rollers on the toner cartridge with the tracks. Push

the toner cartridge until it clicks into place.

Install the unit into the printer by aligning the arrows on the

guides of the unit with the arrows in the printer. Push the unit

as far as it will go.

After you replace the photoconductor kit, reset the

photoconductor counter. To reset the counter, see the

instruction sheet that came with the new photoconductor kit.

Warning—Potential Damage: Resetting the

photoconductor counter without replacing the

photoconductor may damage your printer and void your

warranty.

Close the front door.

Replacing the toner cartridge

When 88 Cartridge is low appears, or when you

experience faded print, remove the toner cartridge. Firmly shake

it side-to-side and front-to-back several times to redistribute the

toner, and then reinsert it and continue printing. When shaking

the cartridge no longer improves the print quality, replace the

toner cartridge.

Note: You can check to see approximately how much toner is left

in your cartridge by printing a menu settings page.