Gardena EasyCut 400/25 사용 설명서 - 페이지 9

{카테고리_이름} Gardena EasyCut 400/25에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena EasyCut 400/25 15 페이지. Turbotrimmer
Gardena EasyCut 400/25에 대해서도 마찬가지입니다: 운영자 매뉴얼 (9 페이지)

페이지 인쇄

7. Troubleshooting

DANGER!

Pulling the filament out

of the filament cassette:

Problem

The trimmer no longer cuts

Filament cannot be

extended or filament

is consumed rapidly

For any other malfunctions please contact the GARDENA service department.

Repairs must only be carried out by GARDENA service departments or specialist

dealers authorised by GARDENA.

Risk of injury from the cutting filament!

v A lways unplug the mains plug of the Turbotrimmer

before troubleshooting.

If a filament is drawn into the filament cassette you can pull it

out again as described below.

1. Remove the filament cassette

6. Maintenance "Replacing the filament cassette".

2. Press together the plastic ring

between your thumb and forefinger.

3. Draw the plastic ring

cassette (use a screwdriver if necessary).

You can now access the filament that was drawn into the

filament cassette.

4. Unwind the cutting filament

through the eye of the plastic ring

welded filament beforehand using a screwdriver, and unwind

and rewind completely.

5. Pull the plastic ring

6. Reinstall the filament cassette

6. Maintenance "Replacing the filament cassette".

Possible Cause

Filament worn or too short.

Filament cassette empty.

Filament drawn into the

cassette or stuck together.

The filament became too dry

and brittle (e. g. over the winter).

Frequent contact between the

filament and hard objects.

as described under

on the filament cassette

over the side part of the filament

by approx. 15 cm and thread it

. If necessary, loosen the

back over the filament cassette

as described under

Remedy

v L engthen the filament

(see 4. Operation "Filament

feed – Tip mechanism").

v R eplace the filament cas sette

(see 6. Maintenance

"Replac ing the filament

cassette").

v P ull the filament out of the

filament cassette (see above).

v P lace the filament in water

for approx. 10 hours.

v Avoid contact between the

filament and hard objects.