Gardena smallCut 사용 설명서 - 페이지 7

{카테고리_이름} Gardena smallCut에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena smallCut 13 페이지. Turbotrimmer
Gardena smallCut에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

1. Maintenance

Cleaning the filament cassette

and area around the filament

cassette :

Fault

The Turbotrimmer

no longer cuts.

If you have any other problems please contact the GARDENA Customer Service.

7. Storage

Storage :

Disposal :

(in accordance with

RL 2002 / 96 / EC)

If the automatic filament feed still does not work after pulling

the filament out of the filament cassette, the filament cassette

and area around the filament cassette may be dirty.

1. Remove the plastic ring

filament cassette

under "Pulling the filament out of the

filament cassette".

2. Unwind the filament

filament cassette and the filament

then wind the filament back onto

the cassette.

3. Clean the automatic mechanism

lever

in the filament cassette

holder

The automatic mechanism lever must move freely.

4. Reinstall the filament cassette as described under "Pulling

the filament out of the filament cassette".

Only GARDENA Service Centres and authorised specialist

GARDENA dealers may carry out repairs.

Possible cause

Filament cassette empty.

Filament too short, drawn into

the cassette or stuck together.

Automatic filament feed is not

working since the automatic

mechanism lever is jammed.

The Turbotrimmer must be stored out of the reach of children.

v Store your Turbotrimmer in a dry place where it is protected

from frost.

Recommended storage :

We recommend that you hang your Turbotrimmer from the cable

lock. Hanging storage helps avoid unnecessary stress on the

cutting head.

The product must not be added to normal household waste. It

must be disposed of in line with local environmental regulations.

v Important: Make sure that the unit is disposed of via your

municipal recycling collection centre.

from the

as described

, clean the

Remedy

v Replace the filament cassette

– see 5. Maintenance

"Replacing the filament

cassette" ).

v Pull the filament out of the

filament cassette (see above).

v Clean the filament cassette

and area around the

cassette (see above).