Gardena 1242 사용 설명서 - 페이지 3

{카테고리_이름} Gardena 1242에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 1242 15 페이지. Programming unit
Gardena 1242에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지), 사용 설명서 (15 페이지)

페이지 인쇄

2. For Your Safety

LCD display :

Programming Unit :

Control Unit :

Wintering :

3. Function

Key allocation

Battery status display

Only alkaline batteries of the type 9 V IEC 6LR61 should be

used to attain the maximum running time of 1 year.

We recommend e.g. the manufacturers Varta and Energizer.

v To prevent data transfer errors, the battery must be replaced

in good time.

It can occur that the LCD display blanks if the outside tempera-

ture is very high or very low. This has no effect whatsoever on

the retention of data and the correct transmission of data.

The LCD display will return when temperature range is back to

normal operating range.

The Programming Unit is splash water proof.

v However, protect the unit from jets of water and do not leave

it within the watering range.

The Control Unit is connected to the Irrigation Valve and is

splash-proof when the cover is closed.

v Ensure that the cover is always closed when the Control Unit

is positioned near the area to be watered.

v Store the Control Unit away from frost at the beginning of the

frosty period or remove the battery.

keys:

Ok key:

Menu key:

Transmit key:

Read key:

The display includes a symbol to indicate the charge condition

of the batteries in the Programming Unit and the Control Unit.

Battery condition in the Programming Unit :

If the voltage falls below a certain level, the symbol Batt. int. will

blink until the battery is replaced. If the battery is not replaced

after the first blinking of symbol Batt. int. it is possible to switch

from the energy-saving to operating mode (approx. 40 times) on

the Programming Unit.

For changing or advancing specific data

already entered. (If you hold down one of

the

keys the display runs through the

hours or minutes, for example, more quickly.)

Confirms the values set using the

Changes the programming level.

Transfers data from the Programming Unit

to the Control Unit.

Transfers data from the Control Unit to the

Programming Unit.

keys.