Fronius 63A-1 빠른 매뉴얼 - 페이지 7

{카테고리_이름} Fronius 63A-1에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fronius 63A-1 20 페이지. Smart meter
Fronius 63A-1에 대해서도 마찬가지입니다: 빠른 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (10 페이지)

Modbus termination switch on the Datamanager 2.0 and the GEN24 inverter:

The internal bus termination 120-Ohm resistance (for Modbus RTU) needs to

be switched to ON. This switch is set to ON by default.

Please Note:

The termination resistance must be activated for the first and last device in an RS485 bus.

2.2 Activating the Fronius Smart Meter on the SnapINverter

It is recommended to complete the Solar.web Wizard first and get the system online. Once

completed please go to Section 2.2.1 for the Fronius Smart Meter activation.

If the system is not being set up for online monitoring the Fronius Smart Meter can be

activated within the Technician Wizard as per Section 2.2.2.

The PV Inverter homepage can be accessed in two ways:

1. Via the Wi-Fi Access Point:

Activate the Wi-Fi Access Point on the Datamanager card (inverter screen under Setup) or

Datamanager Box 2.0

Connect your computer/table/smart phone to the Fronius_240.XXXXXX network

Open a web browser and go to http://192.168.250.181.

Alternatively you can use the Fronius SolarWeb App (Tablet/Smart Phone), open the Solar.web app

and select Settings. Then select "PV Inverter Homepage" or "Your System Monitoring" depending

on your device.

2. Via the LAN Port:

Connect your computer to the Datamanager via LAN cable

Switch the Datamanager IP Switch to Position 'A'

Open a web browser and go to

Once connected follow the below steps:

120 Ω termination

switch

http://169.254.0.180

7/19