Fronius 63A-1 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Fronius 63A-1에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fronius 63A-1 10 페이지. Smart meter
Fronius 63A-1에 대해서도 마찬가지입니다: 빠른 매뉴얼 (17 페이지), 빠른 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

1 GENERAL

Fronius Smart Meters (single phase or 3-phase) are energy meters that work in conjunction with the Fronius

Datamanager V2. The Smart Meter must be connected to the Fronius Datamanager V2 which comes built-in to

all Fronius SnapINverters (Galvo, Primo, Symo and Eco), and can be retrofitted into all other Fronius inverters.

Using a ModBus RTU / RS 485 connection protocol, the smart meter can be utilised to monitor consumption

data or in order to limit the export of a PV system. They can measure current/voltage/energy/reactive

power/apparent power in total or per line.

Once a battery is added to an installation a Smart Meter is mandatory. If the installation is single or dual phase

a 3-phase Smart Meter can be used.

This document describes how to do install and setup the Fronius Smart Meter.

1.1 Requirements

/ Important! The Fronius Smart Meter cannot be used in combination with the Fronius Datamanager Version 1.

/ The Fronius Datamanager V2 needs to have a software version of V3.3.6-13 or greater. (For details how to

upgrade the firmware see chapter 1.3 Software update of Fronius Datamanager).

/ The Datamanager needs to be set up before executing the meter settings. For information on how to set up

the Fronius Datamanager please see the Fronius inverter or the Fronius Datamanager manual (for Fronius

Galvo/Symo/Primo/Eco):

http://www.fronius.com/cps/rde/xbcr/SID-DBD64F5C-

18F6818F/fronius_australia/42_0426_0191_EA_388899_snapshot.pdf

1.2 Where to put the Fronius Smart Meter

Due to the setup of installations in Australia, in most cases the meter will be put into the feed-in path (diagram

1). If the PV system is connected to a sub board it's most likely to achieve the load measurement by having the

meter in the feed-in path. In rare occasion it can be put into the consumption path (diagram 2).

Feed-in point

In this setting the solar generation passes through the meter as well as the site load.

PV System

Loads

(Diagram 1)

Site

Fronius

main

Smart Meter

switch

Grid

3/10