Gardena 1874 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Gardena 1874에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena 1874 17 페이지. Water computer
Gardena 1874에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 사용 설명서 (17 페이지)

페이지 인쇄

1. Press the Menu key twice.

Start and the hours flash on the display.

2. Press the Menu button to jump to the next

programme level

– or –

change programme data with the ▼-▲ buttons

and confirm with the OK button.

When the watering duration is changed while

a program is running, the current watering

cycle is ended.

C) Manual watering:

Each valve can be opened or closed manually

at any time. A program-controlled open valve

can also be closed early without changing the

program data (watering start time, watering dura-

tion and watering frequency). The controller

must be fitted.

1. Select Valve 1 ( ï V1) or Valve 2 (V2 ð ) with

the ▼-▲ buttons.

2. [ Fig. P16 ]: Press Man.-key to open the valve

manually (or to close an open valve).

Run Time and the watering time in minutes (set

minutes in the works) flash for 10 seconds

on the display.

3. [ Fig. P17 ]: Whilst the watering time in minutes

is flashing, the watering duration can be modified

with the ▼-▲ button (between

(example:

minutes) and confirm with the

OK-key.

4. Press Man.-key to close the valve early.

The valve is closed.

The amended manual opening period is stored,

i. e. each time the valve is opened manually in

future the modified opening period is preset. If the

manual opening period is amended to

valve is closed and also remains closed after the

Man.-key is pressed (child lock).

5. MAINTENANCE

Clean filter [ Fig. M1 ]:

(24)

The filter

should be checked regularly and

cleaned when necessary.

(19)

1. Unscrew sleeve nut

hand from the tap thread (do not use pliers).

and

)

0:00

0:59

, the

0:00

of the Water Control by

If the valve has been manually opened and a pro-

grammed start of watering overlaps with the manual

opening duration then the watering programme will

not be carried out.

Example:

The valve is opened at 9.00 a.m. manually, the

opening period is 10 minutes. A program with

a start time between 9.00 and 9.10 a.m. will

not be undertaken in this case.

Reset [ Fig. P18 ]:

The factory settings are restored.

v Press Man.-key and Menu-key simultaneously

for 3 seconds.

All the LCD symbols are displayed for 2 seconds

and the display moves to the normal display.

• All the program data are set to zero.

• The manual watering period is set to

• The time and day of the week are retained.

Important information:

If no entry is made during programming for a period

of more than 60 seconds, the normal display reap-

pears. In this case all changes made up till now will

be applied.

If a sensor is inserted in the Water Control regis-

ters wet (wet), the corresponding programme will

not be carried out.

2. If necessary unscrew the adaptor

3. Remove filter

(24)

from sleeve nut

4. Fit the Water Control again (see 3. INITIAL

OPERATION To connect the Water Control).

again.

0:30

(18)

(19)

and clean.