Gardena AquaContour automatic 8133 사용 설명서 - 페이지 8
{카테고리_이름} Gardena AquaContour automatic 8133에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena AquaContour automatic 8133 12 페이지. Aquacontour automatic.
large-area irrigation
Gardena AquaContour automatic 8133에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)
페이지 인쇄
Clean nozzles :
F
8. Troubleshooting
Fault
Irrigation width smaller than
on initial start-up
Watering pattern uneven
Watering pattern incorrect
In the event of other faults please contact GARDENA Service.
A
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
If the watering pattern is no longer even, the nozzles can be
cleaned using the cleaning needle provided.
The cleaning needle is located on the bottom of the housing.
1. Turn the cleaning needle
(e.g. with a coin) anticlockwise
through 180° and pull out
carefully (bayonet coupling).
G
2. Clean nozzles
with cleaning
F
needle
.
3. Refit cleaning needle
reverse order.
Possible cause
Dirt filter soiled.
Tap not opened sufficiently.
Water pressure too low.
Batteries are flat.
Irrigation range is programmed
incorrectly.
Nozzles soiled.
Nozzle head soiled.
Nozzle head damaged.
Incorrect programme selected.
Large-Area Irrigation
AquaContour automatic
incorrectly positioned
by 180° on ground marker.
F
G
F
in
Remedy
v Clean dirt filter.
v Open tap further.
v Increase water pressure /
water supply.
v Replace batteries. If the
batteries are flat, the range
is reduced to the minimum
level.
v Reprogramme irrigation
range.
v Clean nozzles.
v Clean nozzle head.
v Contact GARDENA Service.
v Keep pressing Menu button
until the correct programme
is selected.
v Re-install Large-Area
Irrigation AquaContour
automatic correctly on
ground marker.
F
17