Gardena AquaContour automatic 8133 Panduan Petunjuk Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Rumput dan Taman Gardena AquaContour automatic 8133. Gardena AquaContour automatic 8133 12 halaman. Aquacontour automatic.
large-area irrigation
Juga untuk Gardena AquaContour automatic 8133: Panduan Petunjuk Pengoperasian (13 halaman)
Halaman Cetak
Clean nozzles :
F
8. Troubleshooting
Fault
Irrigation width smaller than
on initial start-up
Watering pattern uneven
Watering pattern incorrect
In the event of other faults please contact GARDENA Service.
A
Repairs should only be carried out by GARDENA service centres or dealers
authorised by GARDENA.
If the watering pattern is no longer even, the nozzles can be
cleaned using the cleaning needle provided.
The cleaning needle is located on the bottom of the housing.
1. Turn the cleaning needle
(e.g. with a coin) anticlockwise
through 180° and pull out
carefully (bayonet coupling).
G
2. Clean nozzles
with cleaning
F
needle
.
3. Refit cleaning needle
reverse order.
Possible cause
Dirt filter soiled.
Tap not opened sufficiently.
Water pressure too low.
Batteries are flat.
Irrigation range is programmed
incorrectly.
Nozzles soiled.
Nozzle head soiled.
Nozzle head damaged.
Incorrect programme selected.
Large-Area Irrigation
AquaContour automatic
incorrectly positioned
by 180° on ground marker.
F
G
F
in
Remedy
v Clean dirt filter.
v Open tap further.
v Increase water pressure /
water supply.
v Replace batteries. If the
batteries are flat, the range
is reduced to the minimum
level.
v Reprogramme irrigation
range.
v Clean nozzles.
v Clean nozzle head.
v Contact GARDENA Service.
v Keep pressing Menu button
until the correct programme
is selected.
v Re-install Large-Area
Irrigation AquaContour
automatic correctly on
ground marker.
F
17