Gardena FlexControl 1883 사용 설명서 - 페이지 7
{카테고리_이름} Gardena FlexControl 1883에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardena FlexControl 1883 19 페이지. Water computer
페이지 인쇄
3. PUTTING YOUR WATER COMPUTER INTO OPERATION
Insert battery [ Fig. I1 / I2 ]:
The Water Computer must only be operated with
a 9V alkalimanganese (alkaline) battery type IEC
6LR61.
q
1. Remove controller
Water Computer.
2. Insert battery in the battery compartment
Observe correct polarity
The display shows all LCD symbols for 2 seconds
(see 4. PROGRAMMING).
q
3. Install controller
on the housing again.
Connect Water Computer [ Fig. I3 / M1 ]:
The Water Computer is fitted with a sleeve nut
for taps with (G 1") (33.3 mm) thread. The adaptor
e
supplied
allows the Water Computer to be con-
nected to taps with a (G ³⁄₄") thread (26.5 mm).
v Insert the filter
r
into the sleeve nut
nect the water computer to the tap.
from the housing of the
w
.
N
.
t
t
and con-
Connect soil moisture or rain sensor (optional)
[ Fig. I4 ]:
Apart from scheduled watering there is also the
option of including how damp the soil is or rainfall
into the watering programme.
Note:
If the soil is damp enough, the programme will be
stopped, or a programme will be prevented from
starting. Manual operation is possible at all times.
q
1. Remove controller
the Water Computer (see 3. PUTTING YOUR
WATER COMPUTER INTO OPERATION
"Insert battery").
2. Place soil moisture sensor in the watered area
– or – place rain sensor (with extension cable if
necessary) outside the watered area.
3. Run the sensor cable
the housing.
4. Disconnect the cover
z
cable plug
into the sensor connection
the water computer.
It can take up to 1 min. until the status of the
sensor is shown on the display.
from the housing of
z
through the opening of
u
and insert the sensor
i
of
21