Makita 6010D 사용 설명서 - 페이지 9
{카테고리_이름} Makita 6010D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6010D 14 페이지. 10 mm (3/8")
Makita 6010D에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)
페이지 인쇄
*Pressing down too hard on the tool will not speed up the drilling. I n fact, this undue
pressure will only serve to damage the tip of your drill bit, decrease your drilling per-
formance and shorten the service
of
the tool.
*There i s
a
tremendous force exerted on the tool/bit
a t
the time of hole break through.
Grip the drill firmly and exert care when the bit begins to break through the materials.
Item
Screw
Match your bit to your screw.
Nominal Diameter (mm)
B i t No.
Wood Screw
* I
2.1
-
2.7
13/32"
-
lis")
1. Phillips bits
Phillips bit
No.
2 - 45 mm
i s
standard
equipped. Select
your
screws and
right.
nominal diameter with the chart on the
No.
2
3.1
-
4.8 (118''
-
3/16")
2. Slotted bits
Unless you use
a
bit that fits properly the slot on the head of the screw, the slot will
be damaged and the screw will not fasten. If the bit fails to match the slot, use
a
grinder or some such tool t o trim the bit to fit the slot.
NOTE
: Rest the tool for 15 minutes when changing battery for continuous operation.
9