Makita 6010D Kullanım Kılavuzu - Sayfa 9
Matkap Makita 6010D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 6010D 14 sayfaları. 10 mm (3/8")
Ayrıca Makita 6010D için: Kullanım Kılavuzu (17 sayfalar)
Sayfayı Yazdır
*Pressing down too hard on the tool will not speed up the drilling. I n fact, this undue
pressure will only serve to damage the tip of your drill bit, decrease your drilling per-
formance and shorten the service
of
the tool.
*There i s
a
tremendous force exerted on the tool/bit
a t
the time of hole break through.
Grip the drill firmly and exert care when the bit begins to break through the materials.
Item
Screw
Match your bit to your screw.
Nominal Diameter (mm)
B i t No.
Wood Screw
* I
2.1
-
2.7
13/32"
-
lis")
1. Phillips bits
Phillips bit
No.
2 - 45 mm
i s
standard
equipped. Select
your
screws and
right.
nominal diameter with the chart on the
No.
2
3.1
-
4.8 (118''
-
3/16")
2. Slotted bits
Unless you use
a
bit that fits properly the slot on the head of the screw, the slot will
be damaged and the screw will not fasten. If the bit fails to match the slot, use
a
grinder or some such tool t o trim the bit to fit the slot.
NOTE
: Rest the tool for 15 minutes when changing battery for continuous operation.
9