Makita 6176D 사용 설명서 - 페이지 10
{카테고리_이름} Makita 6176D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6176D 17 페이지. Makita cordless driver drill instructions manual 6176d
Makita 6176D에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 부품 목록 (1 페이지)
페이지 인쇄
1. Cover
1
1. Battery terminal
2. Lead wire
3. Battery
Ni-Cd
10
DISPOSING OF TOOL
A Ni-Cd battery is built into the handle of the tool. Always
remove it before disposing of the tool.
Removing built-in battery
002144
CAUTION:
1
•
Never remove the built-in battery from the tool except
when disposing of the tool. The battery will be damaged
or a battery short-circuit could result.
To remove the cover, push it in the direction of the arrow
while pressing down on the "OPEN" portion of the cover.
Withdraw the built-in battery halfway. Disconnect the two
002145
lead wires from the battery by pulling them from the battery
terminals. Then withdraw the battery completely.
To prevent a battery short-circuit, tape the battery terminals
2
or put the battery into a plastics bag. (Note: Never put two or
3
more batteries into one plastics bag. Battery short-circuit
may result.)
CAUTION:
•
Never incinerate the battery even if it is severely
damaged or is completely worn out. It can explode in a
fire or toxic materials can leak out of it.
Recycling the Battery
The only way to dispose of a Makita battery is to recycle it.
The law prohibits any other method of disposal.
To recycle the battery:
1. Remove the battery from the tool.
2. a)
or
b)
Call your nearest Makita Service Center or Distributor to
determine the location that provides Makita battery recycling.
See your local Yellow Pages under "Tools-Electric".
Take the battery to your nearest Makita Factory Ser-
vice Center
Take the battery to your nearest Makita Authorized
Service Center or Distributor that has been desig-
nated as a Makita battery recycling location.
EN0001-1