Makita 6176D 사용 설명서 - 페이지 8
{카테고리_이름} Makita 6176D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6176D 17 페이지. Makita cordless driver drill instructions manual 6176d
Makita 6176D에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 부품 목록 (1 페이지)
페이지 인쇄
ASSEMBLY
1
3
1. Tighten
2. Sleeve
3. Ring
OPERATION
8
Overload protector
The overload protector automatically cuts out to break the
circuit whenever heavy work is prolonged. Wait 20 - 30 sec-
onds before resuming operation.
CAUTION:
•
Always be sure that the tool is switched off before
carrying out any work on the tool.
Installing or removing driver bit or drill bit
002112
CAUTION:
2
•
Always set the reversing switch lever to the neutral
position before installing or removing the bit.
Hold the ring and turn the sleeve counterclockwise to open
the chuck jaws. Place the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve clockwise to tighten
the chuck.
To remove the bit, hold the ring and turn the sleeve counter-
clockwise.
Screwdriving operation
Place the point of the driver bit in the screw head and apply
pressure to the tool. Start the tool slowly and then increase
the speed gradually. Release the trigger just as the screw
bottoms out. If the trigger is not released, the screw may strip
out the hole or the screw and/or bit may be damaged.
NOTE:
•
Make sure that the driver bit is inserted straight in the
screw head, or the screw and/or bit may be damaged.
•
When driving wood screws, predrill pilot holes to make
driving easier and to prevent splitting of the workpiece.
See the chart.