Makita 6202D 사용 설명서 - 페이지 10

{카테고리_이름} Makita 6202D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6202D 16 페이지. Cordless driver drill equipped with electric brake

페이지 인쇄

Adjusting fastening torque

4.5 ( 1 1/64',)

4.8 13/16")

5.1 113164'1

5.5 17/32',)

The fastening torque can be adjusted in six

stages by turning the adjusting ring so that

the pointer on the adjusting ring points t o

a number on the tool body. The fastening

torque is minimum when the pointer points

t o the number

and maximum when it

points to the

marking. The clutch

will slip a t varying torque levels when the

pointer is set a t the numbers 1 to

The

clutch is designed not to slip

a t

the

*\-

marking.

2.9

3.2 17/64'

118'7

3.1

3.4 (1/8"

9/64")

3.3

3.6 (1/8"

9/64"]

3.7

3.9 19/64"

5/32',)

Before actual operation, drive a trial screw into your material or

piece of duplicate

material t o determine which torque level i s required for a particular application.

NOTE :

The adjusting ring cannot be locked with ihe pointer positioned half-way between the

numbers.

Screwdriving operation

Place the point of the driver bit in the

screw head and apply pressure t o the tool.

Start the tool slowly and then increase the

speed gradually. Release the trigger as soon

as the clutch cuts in.

NOTE :

Make sure that the driver bit is inserted straight in the screw head, or the screw and/or

bit may be damaged.

*When driving wood screws, predrill pilot

holes to make driving easier and t o pre-

vent splitting of the workpiece. See the

chart.

5.8 17/32")

6.1 ( 1 5 / 6 4 ' )

4.0

4.2 (5132''

11/64',)

4.2

4.4 (11/64"

11/64")