Makita 6202DW 사용 설명서 - 페이지 8

{카테고리_이름} Makita 6202DW에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6202DW 16 페이지. Cordless driver drill equipped with electric brake

If you charge a battery cartridge from a just-operated tool or a battery cartridge which

has been left in a location exposed t o direct sunlight or heat for a long time, the charg-

ing light may flash in red color. If this occurs, wait for a while. Charging will begin after

the battery cartridge cools. The battery cartridge will cool faster if you remove the

battery cartridge from the f a s t charger.

If the charging light flashes alternately in green and red color and a tone sounds "beep,

beep, beep,

. .

for about

seconds, a problem exists and charging is not possible.

The terminals on the charger or battery cartridge are clogged with dust or the battery

cartridge is worn out or damaged.

If you wish to charge two battery cartridges, allow 15 minutes between chargings on the

fast charger.

Installing or removing driver bit or drill bit

CAUTION :

Always be sure that the tool is switched off and the battery cartridge i s removed before

installing or removing the bit.

To install the bit, push the sleeve up to-

ward the "FREE" side and turn the sleeve

counterclockwise while holding the ring

with your other hand as illustrated a t right.

Place the bit in the chuck

far as it will

go. Hold the ring firmly and turn the sleeve

clockwise to tighten the chuck. Then push

the sleeve down toward the "LOCK" side.

See illustration.

FREEside

LOCK side

\ -

Ring

To remove the bit, push the sleeve up toward the "FREE" side and turn the sleeve

counterclockwise while holding the ring with your other hand.

CAUTION :

Do not attempt to turn the sleeve forcibly when the sleeve is in the "LOCK" position.

The sleeve may be damaged.

.Always push the sleeve down toward the "LOCK" side before operation. I f you operate

the tool with the sleeve in the"FREE" position, the chuck may loosen and the bit may

come out unexpectedly.