Avaya IP OFFICE 2420 사용자 설명서 - 페이지 6

{카테고리_이름} Avaya IP OFFICE 2420에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avaya IP OFFICE 2420 6 페이지. Avaya ip office 2420 quick reference guide
Avaya IP OFFICE 2420에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지), 사용자 설명서 (8 페이지), 최종 사용자 설명서 (19 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (5 페이지), 빠른 참조 매뉴얼 (7 페이지), 사용자 설명서 (9 페이지), 빠른 참조 매뉴얼 (4 페이지), 빠른 매뉴얼 (4 페이지), 빠른 참조 매뉴얼 (4 페이지), 매뉴얼 (6 페이지), 설치 및 안전 지침 (17 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지)

페이지 인쇄
Avaya IP OFFICE 2420 사용자 설명서
PROBLEM: THE 2420 TELEPHONE DOES NOT HAVE DIAL TONE
1
Make sure the handset and line cords at your 2420 telephone are securely connected at both ends.
2
If there is still no dial tone, check with your system manager to verify that your telephone is administered
correctly.
3
If the telephone is administered correctly but there is still not dial tone, remove power. Remove the module
and refer to the 20-Type Stand, 200-Type Module Analog (U.S.) Adjunct Interface, and 201-Type Module
Recorder Interface Installation and Safety Instructions (555-233-132). If the 2420 telephone, without the
module, has dial tone, connect the module to another telephone.
a. If the module works in the new telephone, the 2420 telephone to which the module was originally
connected is faulty.
b. If the new 2420 telephone, after the module has been connected, does not work, the module is faulty.
4
If the original 2420 telephone, without the module, still does not work, find a working 2420 telephone. Unplug
this telephone from its modular wall jack. Plug your 2420 telephone into that jack and verify that it gets dial
tone.
5
If the original 2420 telephone still does not work, plug the working 2420 telephone into your modular wall jack.
If the working 2420 telephone has dial tone, your own telephone is faulty. See your system manager.
Problems Related to External Recorders
The following problems may occur with some external recording devices connected to the 201-type module.
PROBLEM: RECORDING DEVICE DOES NOT START OR STOP
The recording device should be set to "voice activated" mode. Refer to the recording device's user instructions.
PROBLEM: LEVEL OF RECORDING IS TOO LOW OR HIGH
Adjust the volume control on the 2420 telephone during the recorded conversation. A recording device with AGC
(Automatic Gain Control) is recommended.
4