Makita 6228DWE 사용 설명서 - 페이지 12

{카테고리_이름} Makita 6228DWE에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6228DWE 19 페이지. 9.6 v i2 v 14.4 v
Makita 6228DWE에 대해서도 마찬가지입니다: 사용 설명서 (19 페이지), 사용 설명서 (19 페이지), 사용 설명서 (19 페이지)

페이지 인쇄

OPERATION

Nominal diameter of

m d screw (mml

Screwdriving operation

Place the point of the driver bit in the

screw head and apply pressure to the tool.

Start the tool slowly and then increase the

speed gradually. Release the trigger as

soon as the clutch cuts in.

Recommended size of

pilot hole (mml

NOTE:

*Make sure that the driver bit is inserted straight in the screw head, or the screw and/or

bit may be damaged.

3.1 (l/e")

3.5

(W'I

3.8

15/32")

4.5 (11M'I

4.8

(3/16")

5.1 (13,"')

5.5 (7/32"l

5.8 (7/32"1

6.1 (15M"I

*When driving wood screws, predrill pilot

holes to make driving easier and to pre-

vent splitting of the workpiece. See the

chart.

2.0-

2.2

(5/64"

3/32")

2.3

2.5 13/32''

3/32'?

2.5- 2.8

13/32"

7/61',)

2.9

3.2 (7B-I"

1W'I

3.1

3.4 (1W'

9/64")

3.3

3.6 (1W'

9/64")

3.7

3.9 (9/4"

5/32"]

4.0-4.2 W32"

11/64")

4.2-4.4(11/64"- 11/61")

*If the tool is operated continuously until the battery cartridge has discharged, allow the

tool to rest for 15 minutes before proceeding with a fresh battery.

Drilling operation

First, turn the adjusting ring so that the pointer on the tool body points to the

marking.

Then proceed as follows.

*Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a guide

screw. The guide screw makes drilling easier by pulling the bit into the workpiece.

prevent the bit from slipping when starting

hole, make an indentation with

center-

punch and hammer at the point to be drilled. Place the point of the bit in the indentation

and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

*Drilling in metal