Alien Aircraft Corp Hornet K-107 조립 지침 매뉴얼 - 페이지 9
{카테고리_이름} Alien Aircraft Corp Hornet K-107에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alien Aircraft Corp Hornet K-107 17 페이지.
페이지 인쇄
25...Test fit the hatch to the bottom of the fuselage. The front tab
(H-2) slides under part F-11. Slide the hatch slider forward and press
the back end of the hatch down on the fuselage. Move the slider back
to insert it into the slot in former F-6. You can trim the outside edges
of H-2 to center the front of the hatch if required.
26...Use a sanding block to sand all of the fuselage surfaces smooth
and flat. Now lightly sand the edges of the fuselage round. Sand the
back edges of parts LG round. Leave the top, bottom and front
square.
27...Follow the dashed lines to cut and remove the fuselage sides to
make the slot for the stabilizer.
Building the Wing:
28...Cover the right wing plan with wax paper to prevent the parts
from sticking to the plan.
29...Pin the lower 3/32" x 3/16" lower main spar. Align the inboard
end with the wing center line. The outboard end will extend past the
W-9 rib.
30...Glue ribs W-1 thru W-9 into position. Use a small square to make
sure that they are 90 degrees to the building board.
Page 9