Alien Aircraft Corp Hornet K-107 Montagehandleiding - Pagina 9
Blader online of download pdf Montagehandleiding voor {categorie_naam} Alien Aircraft Corp Hornet K-107. Alien Aircraft Corp Hornet K-107 17 pagina's.
Pagina afdrukken
25...Test fit the hatch to the bottom of the fuselage. The front tab
(H-2) slides under part F-11. Slide the hatch slider forward and press
the back end of the hatch down on the fuselage. Move the slider back
to insert it into the slot in former F-6. You can trim the outside edges
of H-2 to center the front of the hatch if required.
26...Use a sanding block to sand all of the fuselage surfaces smooth
and flat. Now lightly sand the edges of the fuselage round. Sand the
back edges of parts LG round. Leave the top, bottom and front
square.
27...Follow the dashed lines to cut and remove the fuselage sides to
make the slot for the stabilizer.
Building the Wing:
28...Cover the right wing plan with wax paper to prevent the parts
from sticking to the plan.
29...Pin the lower 3/32" x 3/16" lower main spar. Align the inboard
end with the wing center line. The outboard end will extend past the
W-9 rib.
30...Glue ribs W-1 thru W-9 into position. Use a small square to make
sure that they are 90 degrees to the building board.
Page 9