ALIEN POWER SYSTEM ESC 매뉴얼 - 페이지 5

{카테고리_이름} ALIEN POWER SYSTEM ESC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIEN POWER SYSTEM ESC 6 페이지.

till the display is correct.

You can now change any setting value from the program area; you also can press the "load factory

default" text to load the factory default value.

After you finish your adjustment press the top-right "write" button, your setting value will be saved into

the ESC.

Disconnect the 4pin wires

cable. When the esc work that cable is powered and if the pin touch a metal part or they touch each

other the esc logic board can be damaged).

Exit the ESC computer software.

* Please note: An EV system is not an RC system. The RC system works to the max power for a few minutes

with a relative small load. EV mean that you ride on the road with a big load for a long time. APS controllers

have been tested on EV with very good results. For EV applications please contact us for more info and

suggestions. You need to consider different mechanical and electronic aspects. Some of the fastest EV on

the market and DIY are powered by RC products ( Battery, motors, controller) because they are the

ultimate in light weight, efficiency and performance. Small and powerful batteries, motors and controllers.

NOTE: We recommend using a lower LiPo battery input when programming for the first time the ESC in

order to practice. This is a precaution to familiarise yourself with the products you are using and to prevent

problems and damage. Do a first no load test to check that everything works fine. Then start to try the full

power of your APS ESC.

Once you are familiar with programming using the program box, it will take about 15 seconds or so to

program the controller once it is connected.

I hope everything is satisfactory, if not, please let us know prior to rating/voting and we will assure you

we will find a solution as soon as possible.

For any questions and requests please feel free to contact us.

ALIEN POWER SYSTEM - PRECISION ELECTRONIC EQUIPMENT

(the 4 metal pin have to stay on the USB cable and not on the ESC program