ALIEN POWER SYSTEM ESC 매뉴얼 - 페이지 3
{카테고리_이름} ALIEN POWER SYSTEM ESC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIEN POWER SYSTEM ESC 6 페이지.
페이지 인쇄corresponding mode is saved.
6.
Hear 1"♪"(Forward mode) or "♪♪" (Forward/Reverse mode), then you can exit the setting mode
after saving the mode.
(When the mode is saved, you can disconnect the ESC to the battery pack)
◎Brake On mode and Brake Off mode:
Hear the first "♪♪♪♪"，put the throttle stick to the middle position, the mode is changed from Brake ON
mode into Brake off mode. If you want to change back, please repeat the above procedures, and vice versa.
◎Timing (motor ignition advance) function value:
1.
Hear 5 groups "" or "♪" or "♪♪" or "♪♪♪" in the above circulation, put the throttle stick to the middle
position.
2.
Timing mode 1: 5 groups "♪"----0~7° (recommended for 2 poles and common motors)
3.
Timing mode 2: 5 groups "♪♪"----8~15° (recommended for 4 poles motors)
4.
Timing mode 3: 5 groups "♪♪♪"----16~23° (recommended for 8 poles motors)
5.
Timing mode 4: 5 groups "♪♪♪♪"----24~30° (recommended for more than 10 poles motors and out
runner motors)
◎Setting of Frequency:
1.
Hear 5 groups"♪-"or 5"♪-♪"or 5"♪♪"in the above circulation, put the throttle stick to the middle
position.
2.
Frequency 1: 5 groups "♪-"----8 kHz ((For common setting, the lowest efficiency loses)
3.
Frequency 2: 5 groups "♪-♪"----16 kHz (recommended for the low internal resistance of motor)
4.
Frequency 3: 5 groups "♪♪"----32 kHz (recommended for the low electrical inductance of motor)
Note: when the timing of motor is saved, please adjust motor on the ground before the flight
You can set all of function value very simply. Setting procedure as follows:
1.
Put the JR pin of the ESC Plug the 4PIN connector of the Prog-Box.
2.
Connect ESC and motor, check illustration below.
3.
Turn on the ESC, and you will hear a beep prompt the connecting is ok and you can go on.
4.
Prog-Box display the APS name first, after 5 seconds or pressing any button it will enter the first
function-MODE TYPE setting interface.
5.
Press← or →button to select the ESC type which you bought from Airplane, Helicopter, Boat, Car，
then press "Forward" button to enter into the second function item-CONTROLLER TYPE. Now press ← or →
button to select the type number of ESC, if your select is right, the motor will beep, prompt the type number
is right.
6.
From now on, you can press Back and Forward button enter into desired function item, then press
← or → button enter into desired value. The motor will beep once press a button ，prompt the setting
value have sent to the ESC.
7.
After setting over, turn off the ESC, disconnect the Prog-Box. The last function value will be record
in the Prog-Box, the next setting can use it again.
Note:
If the ESC you are setting is without BEC, you will have to
power the Prog-Box
Function value setting by program box: