ALIEN POWER SYSTEM ESC 매뉴얼 - 페이지 2

{카테고리_이름} ALIEN POWER SYSTEM ESC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIEN POWER SYSTEM ESC 6 페이지.

Throttle acceleration: Extra soft/Soft/Medium/Hard/Extra hard

This series of ESC can be set simply by transmitter, but more function value settings can only be done via

Program Box or PC via USB link. After connecting with ESC motor, receiver and battery, you can set the

function value

This series ESC can be set with some simple function value by transmitter, but the more function value

setting must be by prog-box or PC via USB link wire。

This ESC has two different types of mode, one is Brake ON mode, and another is Brake Off mode. Change

mode setting procedure as follows:

Move throttle stick on full power position, turn on transmitter. Now when switching on the ESC,

programming sequence will start.

Connect the power battery, turn on receiver.

After approx. 5 seconds, a four-tone melody can be heard; this indicates that a programming

sequence is ready.

You will hear 5 groups of beeps "♪ (a short beep)", then 5 groups of 2 beeps "♪♪", then 5 groups of

3 beeps "♪♪♪"; then 5 groups of 4 beeps"♪♪♪♪" ; and 5 groups of 5 "♪"， Each group of 5 sounds stands

for a different mode of ESC

You can put the throttle stick to the middle position during one group of 5 sounds, and th en the

FUNCTION VALUE:

BATTERY

Type: Ni-XX、Li-XX

Cell count: Auto or manual

LVC mode: Slow cut off/Hard cut off

THROTTLE

Throttle Curve: Logarithmica, linear, exponential

Forwad/ Revervse Points: Auto or manual

Set Ini/End Points: Auto or manual

MOTOR

Motor Timing Degrees: (0% - °30%)

PWM: 8 - 16 – 32

Timing monitor: ON/OFF

Motor check: ON-OFF

Motor Rotation Direction: Clockwise/Anticlockwise

ABS Braking (car only): off -100%

PROP Braking (airplane-heli only): off -100%

Delay Time: 0.25 - 5 seconds (car and Boat only)

PWM Limit (Car/Boat): ON/OFF (%)

Reverse (car/Boat): ON/OFF

Start Power: Auto – 100%

HELICOPTER

Mode -HELI: Contant RPM/Normal RPM

Motor Pole set up: 2-4, 6-10, 12-14 (heli only)

Function value setting by transmitter:

BRAKE

POWER