A&L Furniture Lighthouse with Base 조립 지침 - 페이지 2

{카테고리_이름} A&L Furniture Lighthouse with Base에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. A&L Furniture Lighthouse with Base 3 페이지.

PARTS

(included)

Body

STEP 1

Remove the four screws at the ends of the shipping strips to unfasten from the lighthouse body. (See

photo 1.) Pull the head out of the lighthouse. Remove the shipping strips from the head & discard. (See

photo 2.)

STEP 2

Set the lighthouse body upside down. Place the base upside down on the bottom of the body aligning the

sides as shown. (See photo 3.) Place the six 1½" screws in the predrilled holes in the inside of the base &

screw into the body with the screw gun. (See photos 4 & 5.)

photo 3

Head

Cap

Base

photo 1

HARDWARE

1½" Bolts (2)

1½" Screws (6)

Ground Stakes (2)

Square Drive Bit (1)

TOOLS NEEDED

Screw gun

Phillips Head Screwdriver

Hammer

photo 4

(included)

photo 2

photo 5