AlienTek T100 사용자 설명서 - 페이지 13

{카테고리_이름} AlienTek T100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AlienTek T100 16 페이지. Smart soldering station

ALIENTEK

7. Firmware upgrade

Disconnect the power supply, disconnect the handle and the host, use cable to connect the

USB to TTL serial port module and the host according to the following Figure 7.1

connection.

Press and hold the encoder then power on, wait until the screen displays "Firmware Upgrade"

and release the encoder, as shown in Figure 7.2 below.

Open the firmware upgrade software, select the serial port number, open the serial port, select

the serial port upgrade, open the upgrade file (.atk file), and finally click start upgrade and

wait for the upgrade to complete. The operation is shown in Figure 7.3 below.

T100 Smart Soldering station

Fig 7.1 upgrade connection

Fig 7.2 enter upgrade

User Manual