A&S 2.1 Bar with Wireless Subwoofer 300 사용자 설명서 - 페이지 12

{카테고리_이름} A&S 2.1 Bar with Wireless Subwoofer 300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A&S 2.1 Bar with Wireless Subwoofer 300 16 페이지.

페이지 인쇄

1. Pairing the Wireless Subwoofer with the Soundbar

1. Unplug both units from the mains sockets again, then plug them in again after 3 minutes.

2. Press and hold the PAIR switch on the rear of the subwoofer for a few seconds, the Pair indicator

on the subwoofer will rapidly blink. Then press

unit ON. The Pair indicator on the subwoofer will become solid when successful.

Tip:

After connecting the power, you must press PAIR switch on the subwoofer within 20 seconds to

•

be effective.

•

The subwoofer should be within 6 m of the soundbar in an open area (the closer the better).

•

Remove any objects between the subwoofer and the soundbar.

•

If the wireless connection fails again, check if there is a conflict or strong interference (e.g.

interference from an electronic device) around the location. Remove these conflicts or strong

interferences and repeat the above procedures.

•

If the main unit is not connected with the subwoofer and it is in ON mode, the Pair indicator will

flash.

General Operation

Standby/ON

When you first connect the main unit to the mains socket, the main unit will be in Standby mode.

Press the

button on the unit or on the remote control to switch the unit ON.

Press the

button again on the remote control or on the unit to switch the unit back to STANDBY

mode. The POWER indicator will light up red.

Disconnect the mains plug from the mains socket if you want to switch the unit OFF completely.

If a TV or an external device (Only for AUX socket) is connected, the main unit and the subwoofer

will switch on automatically when the TV or the external device is switched on.

When the unit no input signal (or weak input signal) in AUX, OPTICAL, COAXIAL, HDMI ARC,

Bluetooth for over 15 minutes, the unit will automatically switch to Standby mode.

Select Modes

Press the SOURCE button repeatedly on the unit or on the remote control to select the AUX,

BLUETOOTH, OPTICAL, COAXIAL, HDMI ARC mode.

Indicator

Red

Mode

Standby

Adjust the Volume

Press the VOL+ / VOL- buttons on the unit or on the remote control to adjust the volume.

While adjusting the volume, the status indicator flashes quickly.

While the volume level reaches its maximum level, if you press the VOL+ button again, the status

indicator flashes once. While the volume level reaches its minimum level, if you press the VOL-

button again, the status indicator flashes once.

If you wish to turn the sound off, press the MUTE button on the remote control. Press the MUTE

button again or press the VOL+ / VOL- buttons on the unit or on the remote control to resume

normal listening.

Green

AUX

on the unit or remote control to switch the

Blue

Orange

Optical (solidly)

Coaxial (flash)

White

HDMI ARC