Align Trex 700 Electric conversion 사용 설명서 - 페이지 11

{카테고리_이름} Align Trex 700 Electric conversion에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Align Trex 700 Electric conversion 12 페이지. Nitro electronic conversion kit
Align Trex 700 Electric conversion에 대해서도 마찬가지입니다: 설치 지침 (6 페이지)

페이지 인쇄

Step 9:

You can now install the main gear and rotor head assembly so we can mesh the pinion to main gear

and tighten motor and upper blocks in the frames. Not all main gears are perfectly round so it

would be best to go ahead and pre-mesh the gears and rotate main gear till you find the tightest

point of main gear. Best way to mesh gears is by using a small strip of paper to slip between the

main and pinion gear which would give you a very nice gap between the gears. Go ahead and

tighten the motor mount and upper block making sure that you've used loctite.

The front battery will mount under the front RX tray as seen in the picture. Clean all surfaces of

the tray with rubbing alcohol to allow the sticky back velcro to mate to the surface. Cut a good size

of hooked velcro and cover the entire bottom of the tray. Using the final supplied velcro

strap and mount to RX tray as seen in pictures. Install both batteries and make sure you get them

as close to the motor as possible with battery leads facing the motor. Make sure all wires are secure

yet have enough slack so you don't experience any issues. You will notice the model is perfectly

balanced by following these instructions. You may need to cut off the small servo mount on front

frame stiffener which was designed to adjust nitro engine needle settings. By using a hobby knife or

razor blade, mark the back of the frame stiffener along the edge of the frame and remove. Using a

dremel with a cutoff wheel or any tool you can safely remove the servo mount section of the frame

stiffener which makes it much easier to install and use your front velcro strap.