Align-Pilates H1 Reformer 조립 지침 및 사용자 설명서 - 페이지 5

{카테고리_이름} Align-Pilates H1 Reformer에 대한 조립 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Align-Pilates H1 Reformer 10 페이지.

Assembly

1. Unpacking the H1 reformer

Allowing for space to assemble the reformer, carefully open the box and remove the polystyrene blocks

and other packaging material. The smaller of the two boxes inside the big box contains the ancillary

components. Take this out, open and lay out the contents (leave the carriage bed in the box for now).

Warning: We recommend the H1 reformer is lifted out of its box by two people to minimise the chance of

injury due to its weight. Ensure all springs are engaged to ensure the bed does not roll back when lifting.

To attach the footbar selector bar to the footbar

adjustment arm, insert the bar through the reformer

resting on the selector gear teeth. Then, using the two

bolts with washers and Allen key provided, screw these

into the bar on either side through the hole in the footbar

adjustment arm, as in Fig.1.

1. Levelling the frame

The H1 has 4 adjustable feet to ensure the reformer is

level or it will not run smoothly. The feet are

adjusted by screwing them in or out to adjust the height.

Fig.1

Using a spirit level, adjust the feet to level the frame,

ensuring that each foot is firmly in contact with the floor. Tip: Always lower a high foot before raising a low

foot, to avoid screwing the feet out too far

Elastic retaining strap

2. Assembly of the carriage bed & attaching the ropes

Remove the carriage bed from the H1 frame and lay it

face down on a soft and dry surface, such as clean

carpet, to avoid damaging the leatherette upholstery.

Remove the elastic retaining strap and attach the x4

springs, as shown in Fig.2. Now pass the elastic retaining

strap through the eye of each of the springs and

reattach the hooks to secure the springs (Fig.2).

Fig.2

Locate the pair of rope risers with rope pulleys and the

pair of ropes (Note: each rope has an eyelet on one end). Thread the non eyelet end of each rope

through one of the rope pulleys, see Fig.3, and lay out each rope riser with rope threaded through the

pulley, at the headboard end of the bed. Thread the ropes into the carriage bed, as in Fig.4, which shows

white ropes for illustrative purposes only. Once each rope has been threaded, tie a simple "over-hand"

knot on the end of each rope, then ensure the tails are the same length - once they are pull the knots

tight. You may need to fine tune the final knot position to ensure the ropes are the same lengths. Use the

series of hooks to quickly adjust the length of each rope, as shown in Fig.4. For more details see point 8 on

page 5.

Rope Length Hook Adjusters

Fig.3

Fig.4