AEG 49669GO-MN 사용자 설명서 - 페이지 26

{카테고리_이름} AEG 49669GO-MN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 49669GO-MN 38 페이지. 90cm

페이지 인쇄

INstAllAtIoN of tHE ApplIANcE

Installing splashback

(Model with hob only)

fit splashback to rear of hob with three screws provided .

cabinet requirements

Model 49669GO-MN is designed to fit into a 900mm

wide gap between standard kitchen cabinets . the

appliance integrates with the kitchen cabinets by

matching the height, depth and kick panel . the cooker

may also be installed at the end of a line of benches

or with a free space either side . In addition, a slot-in

type installation is catered for allowing a continuous

cabinetry kick panel to be used . Model BE7900061M

is designed to be built into cabinetry either below a

benchtop or into a vertical cabinet .

• T he cooker must be installed and serviced only by

an authorised person .

• A Certificate of Compliance MUST be supplied to

be kept by the customer .

• T he packing materials must be removed before you

install the cooker .

• T he surrounding kitchen cabinets must be able

to withstand 85°c . Electrolux wIll NOt accept

responsibility for damage caused by installation into

kitchen cabinets which cannot withstand 85°c .

• T he pipes used for installation MUST have sufficient

loops so the cooker can be moved for service (gas

models) .

• T he vents, openings and air spaces MUST NOT

be blocked .

• T he anti-tilt brackets and chain or front stops MUST

be installed to avoid accidental tipping (freestanding

and slot-in models) .

• Y ou MUST NOT lift or pull the cooker by the

door handle .

• The cooker MUST be checked every five years.

• W hen setting the cooker height, ensure the top of

the cooker is at least 10mm higher than the level

of the benchtop .

WARNING!

600mm

Gas hob 910mm

(adjustable 910 – 930mm)

895mm

60mm

15mm (height of

trivet above hob)