Garmin 15L 기술 사양 - 페이지 37

{카테고리_이름} Garmin 15L에 대한 기술 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin 15L 40 페이지. Garmin gps 15l: reference guide
Garmin 15L에 대해서도 마찬가지입니다: 참조 매뉴얼 (1 페이지)

4. Select the serial port to which the

15xH/15xL is connected. Select Auto

to have the program automatically

determine the baud rate, or select

Manual to manually select the baud

rate of the GPS 15xH/15xL. Click OK

when done.

Connect, or select Comm >

5. Click

Connect to connect to the GPS

15xH/15xL.

6. To view the current programming of the

GPS 15xH/15xL, select Config > Get

Configuration from GPS (or press the

F8 key). The current programming of

the GPS 15xH/15xL is displayed in the window, as shown on the previous page.

7. Open the Sensor Configuration

Window by pressing the F6 key or

selecting Config > Sensor

Configuration.

8. Place a check mark in the box next to

Garmin Binary Output to change the

GPS 15xH/15xL to Garmin Mode. The

unit will keep this change in the

programming until you change it again

in the software.

Note: Selecting Config > Switch to

Garmin Mode (or pressing the F11

key) only changes the unit to work in

Garmin Mode until power is cycled

through the unit again. For a more

permanent change, refer to step 8

above.

9. Click OK.

10. When you are ready to upload the

changes into the GPS 15xH/15xL,

select Config > Send Configuration

to GPS (or press the F9 key). The new

configuration is then loaded into the GPS 15xH/15xL.

11. You may disconnect and close the software when finished. The software configuration can

also be saved for future reference.

Refer to

Appendix F: Sensor Configuration Software

the Sensor Configuration Software application.

for complete information about downloading