Alinco DR-510T 사용 설명서 - 페이지 14

{카테고리_이름} Alinco DR-510T에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alinco DR-510T 16 페이지. Vhf/uhf dual band fm transceiver
Alinco DR-510T에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)

페이지 인쇄

TRANSMISSION

Caution

1. Ensure that an antenna with a low

Standing wave ratio (SWR) is

attached to the antenna connector

before attempting to transmit. Fail-

ure to provide proper terminatlon

may result in damage to the final

ampiifier section.

2. Always check to ensure the fre-

quency is clear before transmitting.

A. Simplex Operation

1/2 Dupiex (Repeater)

Operation

1. Select the desired band (VHF,

UHF).

2. Select the desired operating fre-

quency using any of the methods

described above.

3. Press the microphone PTT switch.

The ON AIR indicator will light.

4. Speak into the microphone. The

recommended distance to the mi

crophone is 2 inches (5 cm). Talking

too far away may result in reports of

weak audio.

5. Release the microphone PTT switch

to return to the receive mode. The

ON AIR indicator should go out.

B. Duai Operation

(Fuii Dupiex)

1. Select the desired transmit fre-

quency.

2. Press the F key and select the

Memory "d".

3. Press the F key and the MW key to

Store the transmit frequency into the

Memory "d".

4. Press the F key and the BAND key

to change to other band.

5. Select the receive freqency by the

usual means.

6. Press the SHIFT key to select the

DUAL on the display.

7. Key the PTT switch and you will

transmit on one band while simul-

taneously receive the other band—

Füll Dupiex Cross Band.

-14-