Garmin Zumo 660 설치 지침

{카테고리_이름} Garmin Zumo 660에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin Zumo 660 4 페이지. Garmin gps receiver - car gps user manual
Garmin Zumo 660에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (8 페이지), 소유자 매뉴얼 (48 페이지), 빠른 시작 매뉴얼 (28 페이지), 빠른 시작 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (46 페이지), (독일어) 빠른 시작 가이드 (8 페이지)

zūmo 660 Installation Instructions

Mount Your zūmo on the Motorcyle

Warning: Incorrectly wiring the power cable with bare wire leads can result in

damage to the vehicle or the battery and can cause bodily injury. Garmin strongly

recommends having an experienced installer with the proper knowledge of electrical

systems install the unit.

See the Important Safety and Product Information guide in the product box for product warnings

and other important information.

Step 1: Connect Power to the Mount

Select a suitable and secure location to mount the zūmo on your motorcycle, based on

available power sources and safe cable routing.

Cradle

Power cable

Microphone jack (2.5 mm)

Step 2: Install the Handlebar Base

The zūmo includes parts for two handlebar installation solutions. Custom mounts can

require additional hardware (www.ram-mount.com).

A) To install the U-bolt and handlebar base:

1. Place the U-bolt around the handlebar, and thread the ends through the handlebar

base.

2. Tighten the nuts to secure the base. Do not overtighten.

note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in.

Handlebar

Headphone/audio out jack (3.5 mm)

Bare wires with

inline fuse for

power connection

Mini-USB connector

(for traffic receiever)

Handlebar

base

U-bolt