Garmin Zumo 660 Installatie-instructies

Blader online of download pdf Installatie-instructies voor {categorie_naam} Garmin Zumo 660. Garmin Zumo 660 4 pagina's. Garmin gps receiver - car gps user manual
Ook voor Garmin Zumo 660: Snelstarthandleiding (8 pagina's), Snelstarthandleiding (8 pagina's), Gebruikershandleiding (48 pagina's), Snelstarthandleiding (28 pagina's), Snelstarthandleiding (8 pagina's), Handleiding voor installatie-instructies (46 pagina's), (Duitse) Beknopte handleiding (8 pagina's)

zūmo 660 Installation Instructions

Mount Your zūmo on the Motorcyle

Warning: Incorrectly wiring the power cable with bare wire leads can result in

damage to the vehicle or the battery and can cause bodily injury. Garmin strongly

recommends having an experienced installer with the proper knowledge of electrical

systems install the unit.

See the Important Safety and Product Information guide in the product box for product warnings

and other important information.

Step 1: Connect Power to the Mount

Select a suitable and secure location to mount the zūmo on your motorcycle, based on

available power sources and safe cable routing.

Cradle

Power cable

Microphone jack (2.5 mm)

Step 2: Install the Handlebar Base

The zūmo includes parts for two handlebar installation solutions. Custom mounts can

require additional hardware (www.ram-mount.com).

A) To install the U-bolt and handlebar base:

1. Place the U-bolt around the handlebar, and thread the ends through the handlebar

base.

2. Tighten the nuts to secure the base. Do not overtighten.

note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in.

Handlebar

Headphone/audio out jack (3.5 mm)

Bare wires with

inline fuse for

power connection

Mini-USB connector

(for traffic receiever)

Handlebar

base

U-bolt