Alivida Sauna Controller 설치 및 운영 매뉴얼 - 페이지 18

{카테고리_이름} Alivida Sauna Controller에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alivida Sauna Controller 19 페이지.

Meldingen en foutcodes

Error Message Description

E1_1

Communicatie

problem between

controller and display

E2_1

Thermal protection

Temperature out of range

E2_2

from 1°C / 125°C

Display defect

NESS

RGB Control not working

due to communication

problem between

controller and RGB box

Service interval

It is possible to set a service interval message, which will appear in the display after a preset number

of hours has elapsed. In the low level menu go to parameter 10. Here you can adjust the value

from 0 to 100 hours with the arrow keys to the left and to the right. It is not necessary to confirm the

value in this parameter. When the number of hours set in parameter 10 has elapsed, a spanner with

screwdriver will appear in the display. This service interval message can be reset in the low level menu.

Go to parameter 10, hold the option button for 2 seconds. You will then arrive at the submenu.

Pressing and holding the aroma button for 2 seconds resets the service interval counter.

By pressing the power button you leave the low level menu.

Possible cause

Bad connection between display and

controller

Display or controller malfunction

Controller failure

Thermal cut-out problem

Thermal cut-out position incorrect

Cable connection lost

Temperature sensor defective

Sensor cable connection broken

Overheating

Dip switch setting wrong. Cable

connection lost

Solution

Reset

Fix the error

Reset

Replace display

Check installation