Garmin GTN 625 활성화 지침 - 페이지 20

{카테고리_이름} Garmin GTN 625에 대한 활성화 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTN 625 46 페이지. Gps/sbas navigation system as installed in cessna 172r
Garmin GTN 625에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 매뉴얼 보충 자료 (31 페이지), 오류 (4 페이지), 사용자 설명서 (22 페이지), 비행 매뉴얼 (49 페이지), 파일럿 매뉴얼 (28 페이지)

페이지 인쇄
Garmin GTN 625 활성화 지침
5. Refer to Table 4-1 to read the SAT ID/CONNECTIVITY information.
6. Verify radio IDs and signal quality is between 2 – 3. If signal quality is zero, check the antenna and
wiring.
„- -„
„XM‟
„X0‟, „X1‟, „X2‟, or „X3‟
„-0‟, „-1‟, „-2‟, or „-3‟
"Searching..."
"Satellite in view"

4.3 Verify XM Subscribed Services

The 430/530 supports the following weather services: NEXRAD, graphical METAR, text-based
METAR, Wind, and Graphical Temperature/Dew Point. These services are available only in the
United States. Verify included services by displaying them on the unit, if applicable. If signal quality is
between 1 and 3, but no data is displayed, contact XM Satellite Radio to verify subscription. Be sure that
the unit is updated with the most current software.
Page 14
GDL 69/69A XM Satellite Radio Activation Procedures

Figure 4-2. Data Link Status Page

Table 4-1. Data Link Status

SAT ID Field
GDL 69/69H – 430/530 Series interface communications not yet established.
GDL 69/69H not yet communicating with internal satellite radio hardware (normal
during power-up).
„X‟ = Satellite radio service activated. Satellite signal quality is indicated by the
numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
„-‟ = Satellite radio service is not activated. Satellite signal quality is indicated by
the numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
Connectivity Field
No satellite is currently in view, signal quality is „0‟.
Indicates a signal quality between 1 and 3.
190-00355-04
Rev. J