Brother 884-B02 사용 설명서 - 페이지 23

{카테고리_이름} Brother 884-B02에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 884-B02 38 페이지. Compact overlock machine

4. Holding all threads with your left hand, turn the

hand wheel slowly a few times toward you,

and check to see that the threads entwine

themselves before using the foot controller to

sew.

Chaining-off

After test-sewing, continue to depress the foot

controller slightly and chain off 10 cm (4 inches).

The threads will entwine themselves into a chain

automatically.

NOTE:

If the thread tension is not correctly balanced, the

chaining-off result will be uneven. If this happens,

pull the threads slightly. Check the threading order

and adjust the thread tension to create an even

chain. (See CHAPTER 1 "Tension adjustment

dial".)

1. Thread the machine and pull all threads out

about 15 cm (6 inches) behind the presser foot.

2. Lift the presser foot and place the material well

underneath the presser foot before starting to

sew. Slowly sew a few stitches by turning the

hand wheel.

3. The fabric will be fed automatically. You need

only guide it in the required direction.

4. Check the stitch formation (stitch chain) to

see if it is uniform. If the stitch is not uniform,

re-check that the threading has been done

properly and in sequence.

5. Follow the Seam Allowance Guide for

consistent cutting of the fabric seams. The

scale of Seam Allowance Guide shows 9.5,

12.7, 15.9, and 25.4 mm (3/8, 1/2, 5/8, and 1

inches) when the stitch width dial is set to "5".

1 Presser foot 2 Upper knife 3 Seam Allowance Guide

When the seam is ﬁ nished, keep the machine

running at a low speed to obtain chaining-off. Then

cut the stitches 5 cm (2 inches) from the work.

If feeding for chaining-off is not enough, pull the

thread gently.