Brother 884-B02 사용 설명서 - 페이지 33

{카테고리_이름} Brother 884-B02에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 884-B02 38 페이지. Compact overlock machine

페이지 인쇄

5. Set the stitch length control lever.

- Tapes: between "3" and "4"

- Elastics: "4"

6. Adjust the presser adjusting dial 2

- at "0" when sewing with tapes.

- at desirable number for contraction when

sewing with elastics.

NOTE:

Contraction will be increased with larger

number.

7. Make trial sewing and adjust thread tensions.

Example of proper sewing seam:

<A>

<A> Surface

Tape

<C> Surface

<D> Elastic

NOTE:

Thread tensions are alike to normal over

edging when sewing with tapes.

It is recommendable to have a stronger tension

for under looper and over looper for beautiful

ﬁ nish.

It is advisable to make trial sewing on each

material / thread due to different contraction.

Pearl sequence foot

Features

By using the pearl sequence foot, you can

bead on fabric. It is useful for decorated edge of

curtain, table cloth, dress, etc. From 3mm to 5mm

sequential pearl can be sewn with this foot.

Preparation

1. Retract the knife (see CHAPTER 1 "Retracting

knife").

2. Attach the pearl sequence foot (see CHAPTER

1 "Attaching/ Removing presser foot").

3. Set up the machine for 3 thread overlock stitch

with one needle in the left position.

The right needle should be removed.

How to adjust the machine

1. Adjust the stitch length according to the length

2. Adjust stitch width 3 to 5mm.

3. Adjust thread tension as follows:

<C>

How to set fabric and pearl

<D>

1. Fold the fabric according to the line for pearl

2. Place the fabric at needle dropping point

3. Use the screw 2 and adjust the clearance

4. Place the pearl through the guide just front of

Test sewing

1. Sew turning hand wheel by hand until the pearl

2. Sew at slow speed while guiding the pearl and

3. Tie both end of thread at the beginnig and end.

NOTE:

Thread tension is easy to loosen especially for

small size pearl. Retract movable stitch tongue for

better stitching.

as <A> or . For example, 4mm stitch length

means 4mm for <A> or .

<A>

Needle thread: slightly decrease

Over looper thread: slightly decrease

Under looper thread: slightly increase

1 ~ 1.5mm

ﬁ tting.

keeping the folded edge with guide 1.

between folded edge needle so that it becomes

1mm to 1.5mm.

guide tunnel 3.

comes through the tunnel.

fabric by hand.

<A>