Garmin NavComm SL30 사용자 설명서 - 페이지 27

{카테고리_이름} Garmin NavComm SL30에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin NavComm SL30 48 페이지. Vhf transceiver
Garmin NavComm SL30에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 설치 (2 페이지)

페이지 인쇄

OBS Mode

OBS Operation

OBS mode enables the VOR CDI which is displayed on

the right side. The OBS course setting is shown in the

center of the display. The

mode. If OBS mode is allowed in the unit's installed

configuration, the annunciator over the

light. The knobs adjust the OBS setting in this mode

rather than the frequencies. The

course by tens (00-35 in higher digits). The

adjusts single degrees.

OBS Direct-To

You can navigate Direct-To a VOR. In Nav mode with a

VOR as the Active frequency, press

will now center in the TO condition.

OBS Mode Disabled

If the active frequency is a localizer, OBS mode is not

available. Instead, the CDI is always displayed with loc

appearing to its left.

OBS mode and the CDI display for VORs are not

available if the SL30 is installed with an indicator head

that uses a composite converter.

CDI

A CDI display is also available for VORs. The OBS course

setting is displayed to the left of the CDI. The CDI

graphic is dashed and marked "flagged" when no

signal is received. If you enabled the "Display Ident over

OBS" selection in System mode, the Morse code station

identifier will replace the OBS value when it receives the

identifier message.

111.80 s117.40

OBS

button is used to select this

OBS

LARGE

knob adjusts the

OBS

twice. The CDI

fr A}}}

120

120 ---flagged---

Advanced Operation

button will

SMALL

knob