Brother 888X64 Series 운영 매뉴얼 - 페이지 17

{카테고리_이름} Brother 888X64 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother 888X64 Series 48 페이지.
Brother 888X64 Series에 대해서도 마찬가지입니다: 운영 매뉴얼 (2 페이지), 운영 매뉴얼 (47 페이지), 운영 매뉴얼 (2 페이지), 운영 매뉴얼 (48 페이지), 운영 매뉴얼 (3 페이지)

페이지 인쇄

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Lower threading (for

models equipped with a

quick-set bobbin)

Install the bobbin wound with thread.

This feature is only available on certain models.

Follow steps

threading" on page 15.

While lightly holding down the bobbin

with your right hand as shown, guide the

thread through the slit (1 and 2). Then,

pull the thread toward you to cut it with

the cutter (3).

• At this time, check that the bobbin easily

rotates counterclockwise.

1 Slit

2 Cutter (Cut the thread with the cutter.)

Note

● If the thread is not correctly inserted through

the tension-adjusting spring of the bobbin

case, it may cause incorrect thread tension.

1 Tension-adjusting spring

from "Lower

Replace the bobbin cover. Put the

projection into the race retainer groove

and push closed.

1 Groove

2 Projection

• Start sewing after threading the lower and

upper thread. When sewing gathers or darts,

you can draw up the lower thread by hand so

that some thread will be left over. Refer to the

steps in "Drawing up the lower thread"

(page 21).