Garmin GTX 330 파일럿 매뉴얼 - 페이지 6

{카테고리_이름} Garmin GTX 330에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 330 13 페이지. Equipment supplement
Garmin GTX 330에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 (12 페이지), 파일럿 매뉴얼 (13 페이지), 파일럿 매뉴얼 (8 페이지), 파일럿 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 설치 매뉴얼 (49 페이지)

Function Display

NOTE: GTX 330 options are normally set at time of installation. For changes

to the GTX 330 parameters, contact your Garmin authorized dealer.

CRSR Initiates starting time entry for the Count Down timer and

cancels transponder code entry.

CLR Resets the Count Up, Count Down, and Flight timers. Cancels

the previous keypress during code selection and Count Down entry.

Returns cursor to the fourth code digit within five seconds after entry.

8 Reduces Contrast and Display Brightness when the respective fields

are displayed (dependent upon installation configuration) and enters

the number eight into the Count Down timer.

9 Increases Contrast and Display Brightness when the respective

fields are displayed (dependent upon installation configuration) and

enters the number nine into the Count Down timer.

FLIGHT ID: Displays the Flight ID. The CRSR key opens the Flight

ID entry dialog if the 'ALLOW PILOT TO EDIT FLT ID' option is en-

abled during installation configuration.

PRESSURE ALT: Displays the altitude data supplied to the GTX 330

in feet, hundreds of feet (i.e., flight level), or meters (dependent upon

installation configuration).

FLIGHT TIME: Timer start is configured as either Manual or Au-

tomatic. When Manual, displays the Flight Time, controlled by the

START/STOP and CLR keys. When Automatic, the timer begins when

takeoff is sensed.

ALTITUDE MONITOR: Controlled by START/STOP key. Activates

a voice alarm and warning annunciator when altitude limit is exceed-

ed.

OAT/DALT: Displayed when the GTX 330 is configured with tem-

perature input. Displays Outside Air Temperature and Density Alti-

tude.

COUNT UP TIMER: Controlled by START/STOP and CLR keys.

COUNT DOWN TIMER: Controlled by START/STOP, CLR, and

CRSR keys. The initial Count Down time is entered with the 0 – 9

keys.