Garmin GPSMAP 8700 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} Garmin GPSMAP 8700에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GPSMAP 8700 27 페이지.
Garmin GPSMAP 8700에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (8 페이지)

페이지 인쇄

NMEA 0183 Connection Considerations

• The chartplotter provides one Tx (transmit) port and one Rx (receive) port.

• Each port has 2 wires, labeled A and B according to the NMEA 0183 convention. The corresponding A and B

wires of each internal port should be connected to the A (+) and B (-) wires of the NMEA 0183 device.

• You can connect one NMEA 0183 device to the Rx port to input data to this chartplotter, and you can connect

up to three NMEA 0183 devices in parallel to the Tx port to receive data output by this chartplotter.

• See the NMEA 0183 device installation instructions to identify the transmit (Tx) and receive (Rx) wires.

• You must use 28 AWG, shielded, twisted-pair wiring for extended runs of wire. Solder all connections and seal

them with heat-shrink tubing.

• Do not connect the NMEA 0183 data wires from this device to power ground.

• The power cable from the chartplotter and the NMEA 0183 devices must be connected to a common power

ground.

• The internal NMEA 0183 ports and communication protocols are configured on the chartplotter. See the

NMEA 0183 section of the chartplotter owner's manual for more information.

• See the chartplotter owner's manual for a list of the approved NMEA 0183 sentences that the chartplotter

supports.

NMEA 0183 Device Connections

This diagram illustrates two-way connections for both sending and receiving data. You can also use this

diagram for one-way communication. To receive information from a NMEA 0183 device, refer to items

, and

when connecting the Garmin device. To transmit information to a NMEA 0183 device, refer to

items

, and

when connecting the Garmin device.