Garmin GPSMAP 8700 Kurulum Talimatları Kılavuzu - Sayfa 9
Deniz GPS Sistemi Garmin GPSMAP 8700 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Garmin GPSMAP 8700 27 sayfaları.
Ayrıca Garmin GPSMAP 8700 için: Kurulum Talimatları Kılavuzu (6 sayfalar), Kurulum Talimatları Kılavuzu (8 sayfalar)
Sayfayı Yazdır
NMEA 0183 Connection Considerations
• The chartplotter provides one Tx (transmit) port and one Rx (receive) port.
• Each port has 2 wires, labeled A and B according to the NMEA 0183 convention. The corresponding A and B
wires of each internal port should be connected to the A (+) and B (-) wires of the NMEA 0183 device.
• You can connect one NMEA 0183 device to the Rx port to input data to this chartplotter, and you can connect
up to three NMEA 0183 devices in parallel to the Tx port to receive data output by this chartplotter.
• See the NMEA 0183 device installation instructions to identify the transmit (Tx) and receive (Rx) wires.
• You must use 28 AWG, shielded, twisted-pair wiring for extended runs of wire. Solder all connections and seal
them with heat-shrink tubing.
• Do not connect the NMEA 0183 data wires from this device to power ground.
• The power cable from the chartplotter and the NMEA 0183 devices must be connected to a common power
ground.
• The internal NMEA 0183 ports and communication protocols are configured on the chartplotter. See the
NMEA 0183 section of the chartplotter owner's manual for more information.
• See the chartplotter owner's manual for a list of the approved NMEA 0183 sentences that the chartplotter
supports.
NMEA 0183 Device Connections
This diagram illustrates two-way connections for both sending and receiving data. You can also use this
diagram for one-way communication. To receive information from a NMEA 0183 device, refer to items
,
, and
when connecting the Garmin device. To transmit information to a NMEA 0183 device, refer to
items
,
,
,
, and
when connecting the Garmin device.
,
,
9